Door sensor metal
Door position sensor (IO102-20/B2P). The sensor is designed to be mounted on a metal door of a cabinet or a room. It contains reed contacts ("dry contact").
The sensor IO102-20/B2P determines if a door of a room or a closet with equipment is opened or closed. The sensor is a patch one, it consists of two halves. A half with reed contacts and connected wires is mounted still while another half with magnet is mounted on the door. When the door is being closed, a magnet approaches reed contacts and closes them. When the door is being opened, a magnet moves away and contacts open. A peculiarity of this sensor is in a possibility to mount it on a metal door.
The sensor is pluggable to NetPing/Uniping devices. When the sensor is triggered, a device can send E-mail, SMS, and SNMP TRAP notifications. The sensor is hooked up to one of IO lines of a device and a GND terminal using 2 wires. In the interface of a device, it is displayed as a status of the IO line, to which it is hooked up.
Information about a sensor plugin is in the document "User Guide" for a device, to which you connect a sensor. Information about configuring a sensor and its functionality is in the document "Firmware Description" for a device, to which you connect a sensor.
A sensor is designed to be mounted on metal surfaces.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with the help of flat cable extenders of RC-4 sensor, which are sequentially plugged one into another. Or it can be done independently with the help of any wire with a minimum cross section of 0,4 mm2. Maximum allowable length of a flat cable is 100 m.
|Device dimenstions||53 x 40 x 30|
|Sensor cord length||2 m.|
|Device suit||Sensor with modified cable, magnetic part of the response, zip package|
NetPing IO v2
UniPing server solution v3/SMS
UniPing server solution v3
NetPing 2/PWR-220 v1/SMS
NetPing 2/PWR-220 v2/SMS
NetPing 2/PWR-220 v3/ETH
NetPing 4/PWR-220 v3/SMS
NetPing 8/PWR-220 v3/SMS