Water Leakage Detection Sensor (mod. FLWS-60BSL-5-2)
- 38.00 USD
Water Leakage Detection Sensor is a “dry contact“ type sensor that can be put simply on the ground or mounted on a flat surface.
Aluminium allow body with mounting holes;
Has grooves that allow leaked water to reach the electrodes;
LED indicator to visually confirm conditions;
<50ms response time;
60 mm in diameter;
2 m cable length;
Operating temperature range -5…+60C
5V DC power supply.
A Water Leakage Detection Sensor can be connected to NetPing server room environmental monitoring units and power distribution units, or another device that supports a “dry contact“ interface type.
You can effectively use it at the following facilities:
base transmission stations (cell towers);
rooms with equipment;
The device exposes two electrode probes (normally open) at the bottom of the sensor. The housing 60 mm in diameter is made of aluminium allow with grooves allowing leaked water to reach the sensor electrodes in case the sensor mounted on a flat surface. The sensor provides relay contact output when the water touch the probes, the relay in the sensor turns on and signals to external alarm circuit.
Two holes on the flange allow mount the sensor on a flat surface (wall, floor) with screws or it can be simply put on the ground. The device is equipped with a LED indicator, which is green when it is powered up and red when the changed conditions trigger the relay to signal an alarm about water leakage.
Please find the information on how to connect the sensor in the "User Manual" for the device you use. For any information on the sensor configuration and functionality, please refer to the Firmware Description document for the device to which you are connecting the sensor.
The sensor comes fitted with a non-detachable cable, which connects to the IO-lines of a device. The cable length can be increased by using Cables 4 extender, 4m, which may be connected in a chain. It is also possible to increase the length of the cable independently using any wire with a cross-section of at least 0.4 square mm. The maximum permissible loop length is 100 meters.
|Device suit||Sensor, package|
|Device dimensions||60 x 60 x 32|
|Operating temperature range||-5…+60 °C|
|Sensor cord length||1 x red for alarm 1 x green for operational readiness|